Assembling And Installing The Front Brake; Master Cylinder - Yamaha YZF-R1S Service Manual

FRONT AND REAR BRAKES
EAS00607
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER
WARNING
S Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
S Never use solvents on internal brake com-
ponents.
Recommended brake fluid
1. Install :
S brake master cylinder kit
S circlip
S dust boot
2. Install:
S brake master cylinder 1
NOTE:
S Install the brake master cylinder holder with
the "UP" mark a facing up.
S Align the end of the brake master cylinder
holder with the punch mark b on the right han-
dlebar.
S First, tighten the upper bolt, then the lower bolt.
There should be 2 X 2.5 mm (0.08 X 0.10 in)
for clearance between the right handlebar
switch and the brake master cylinder holder.
3. Install:
S copper washers
S brake hose
S union bolt
S brake light switch coupler
WARNING
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
4-29
CHAS
DOT 4
New
13 Nm (1.3 mSkg, 9.4 ftSlb)
New
30 Nm (3.0 mSkg, 22 ftSlb)