Wiper Module Removal; Installation - Chrysler 300M Service Manual

LH
WIPER LINKAGE (Continued)
(1) Install "U" nut to body (if necessary).
(2) Install the module linkage mounting grommets.
NOTE: When assembling master link or slave link to
module frame, use channel locks wrapped in cloth
to prevent damage to ball and socket joint. Apply
light pressure to assemble socket to ball.
(3) Connect the wiper module master link to the
pivot lever and motor crank by carefully snapping
together. Do not damage ball and socket or seal.
(4) Connect wiper module slave link to pivot levers
by carefully snapping together. Do not damage ball
and socket or seal.
(5) Install the wiper module into the vehicle. Refer
to Electrical, Wipers and Washers, Wiper Module

Installation.

(6) Connect the negative battery cable remote ter-
minal to the remote battery post.
WIPER MODULE
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove driver and passenger side wiper arms.
Refer to Electrical, Wipers and Washers, Wiper Arm
Removal.
(3) Remove nine screws to cowl screen panel. Refer
to Body for Removal.
(4) Remove wiper module mounting bolt located on
top of the tower to tower beam.
(5) Remove eight bolts to Tower to Tower (crosscar)
support (Fig. 14). Refer to Body for Removal.
Fig. 14 TOWER TO TOWER SUPPORT REMOVAL
1 - TOWER TO TOWER SUPPORT
2 - RETAINING BOLTS
(6) Remove three retaining bolts to windshield
wiper module (Fig. 15).
(7) Lift wiper module away from vehicle body.
(8) Disconnect one wire connector.
(9) Remove windshield wiper module from vehicle.
Fig. 15 WIPER MODULE RETAINING BOLTS
1 - RETAINING BOLTS
2 - WIPER MOTOR CONNECTOR
(10) If replacing module, transfer wiper module
grommets to new module assembly (Fig. 16).
Fig. 16 WIPER FRAME GROMMETS
1 - GROMMETS
(11) Remove one nut to crank arm and remove
from motor (Fig. 17).
(12) Remove three retaining bolts from wiper
motor (Fig. 17).
(13) Remove wiper motor from wiper module
assembly. Install onto new wiper module assembly.
Refer to Electrical, Wipers and Washers, Wiper
Motor, Removal.
INSTALLATION
(1) Install the wiper motor onto the wiper module
assembly. Refer to Electrical, Wipers and Washers,
Wiper Motor, Removal.
(2) Install the three retaining bolts to the wiper
motor (Fig. 17).
(3) Install the crank arm and install the one nut to
crank arm (Fig. 17).
NOTE: If replacing module, transfer wiper module
grommets to new module assembly (Fig. 16).
(4) Install the windshield wiper module into vehi-
cle.
WIPERS/WASHERS 8R - 21