Installation; Center High Mounted Stop Lamp Unit Removal - Chrysler 300M Service Manual

8L - 8 LAMPS/LIGHTING - EXTERIOR
CENTER HIGH MOUNTED STOP LAMP (Continued)
(4) Disconnect lamp socket from housing (Fig. 6).
(5) Remove bulb from socket.
Fig. 6 CHMSL - INTREPID
1 - TRUNK LID APPLIQUE AND CHMSL
2 - BODY WIRING AND LAMPS
3 - PLASTIC HEX NUT
300M
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Release decklid latch and open decklid.
(3) Remove decklid cover.
(4) Disconnect lamp socket(s) from housing (Fig.
7).
(5) Remove bulb(s) from socket(s).
Fig. 7 CHMSL - 300M
1 - CHMSL LAMP
2 - TRUNK LID LOWER EDGE

INSTALLATION

CONCORDE
(1) Install the bulb into the socket.
(2) Install socket into CHMSL housing.
(3) Connect the battery negative cable and close
the hood.
(4) Verify CHMSL operation.
INTREPID
(1) Install bulb into socket.
(2) Install socket into housing.
(3) Connect negative battery cable and close hood.
(4) Verify CHMSL operation.
(5) Install decklid cover.
300M
(1) Install bulb(s) in socket(s).
(2) Install socket(s) into housing.
(3) Connect battery negative cable and close hood.
(4) Verify CHMSL operation.
(5) Install decklid cover.
CENTER HIGH MOUNTED
STOP LAMP UNIT
REMOVAL
CONCORDE
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Release decklid latch and open decklid.
(3) From under rear
CHMSL wire connector from body harness.
(4) Remove rear shelf upper panel.
(5) Remove fasteners attaching the CHMSL to rear
shelf upper panel (Fig. 8).
(6) Remove CHMSL from rear shelf upper panel.
INTREPID
(1) Release decklid latch and open decklid.
(2) Remove decklid cover.
(3) Disconnect CHMSL wire connector from body
harness (Fig. 6).
(4) Remove fasteners attaching CHMSL and appli-
que to the decklid.
(5) Remove CHMSL from decklid.
300M
(1) Release decklid latch and open decklid.
(2) Remove decklid cover.
(3) Disconnect CHMSL wire connector from body
harness (Fig. 7).
(4) Remove fasteners attaching CHMSL to the
decklid.
LH
shelf panel, disconnect