Chrysler 300M Service Manual page 227

7 - 40 TRANSMISSION
TRANSMISSION OIL COOLER (Continued)
(3) Reposition the A/C condenser to allow access to
condenser rear surface.
(4) Remove the previously cut-off cooler retaining
straps.
(5) Position and install the new retaining straps in
the same locations on the condenser.
(6) Reposition A/C condenser on the radiator upper
retainers.
(7) Install the A/C condenser mounting bolts and
tighten to 5 N·m (45 in. lbs.) (Fig. 3).
(8) Install the foam pads on the retaining straps
(9) Position the transmission oil cooler on A/C con-
denser by guiding the retaining straps through the
cooler mounting holes (Fig. 2).
(10) Position the external cooler lines to the side of
radiator. Install support bracket and screw (Fig. 4).
(11) Install the retaining strap locks and tighten to
secure the cooler to the condenser. Trim off the
excess strap material.
(12) Connect the cooler hoses to cooler lines and
tighten hose clamps to 3 N·m (28 in. lbs.).
(13) Install radiator side air shields.
(14) Install the front fascia (Refer to 13 - FRAMES
& BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION).
(15) Install the front wheels
(16) Install the radiator upper support (Refer to 23
- BODY/EXTERIOR/GRILLE
FORCEMENT - INSTALLATION).
(17) Connect negative
jumper terminal.
OPENING REIN-
cable cable to remote
Fig. 4 A/C CONDENSER TO RADIATOR
1 - TRANS COOLER LINE BRACKET SCREW
2 - SCREW - CONDENSER TO RADIATOR
3 - TRANS COOLER
4 - SCREW - CONDENSER TO RADIATOR
(18) Start engine and check transmission oil level.
Adjust level as necessary.
LH