Removal; Installation - Chrysler 300M Service Manual

8L - 14 LAMPS/LIGHTING - EXTERIOR
FOG LAMP UNIT (Continued)
Fig. 16 FOG LAMP UNIT ADJUSTER SCREW -
CONCORDE
1 - UP/DOWN ADJUSTER SCREW
2 - FOG LAMP UNIT
Fig. 17 FOG LAMP UNIT ADJUSTER SCREW - 300M
1 - UP/DOWN ADJUSTER SCREW
2 - FOG LAMP UNIT

REMOVAL

(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Remove screw(s) attaching fog lamp to fascia
(Fig. 18), (Fig. 19), and (Fig. 20).
(3) Pull fog lamp forward from opening in front
bumper fascia.
(4) Disconnect fog lamp wire connector from front
lighting wire harness.
(5) Remove fog lamp from vehicle.

INSTALLATION

(1) Connect fog lamp wire connector to front light-
ing wire harness.
(2) Insert fog lamp rearward into opening in front
bumper fascia.
(3) Install screw(s) attaching fog lamp to fascia.
Fig. 18 FOG LAMP - INTREPID
1 - FOG LAMP
2 - SCREW
Fig. 19 FOG LAMP - CONCORDE
Fig. 20 FOG LAMP - 300M
1 - SCREWS
2 - FOG LAMP
(4) Connect the battery negative cable and close
hood.
LH