Chrysler 300M Service Manual page 243

8A - 14 AUDIO/VIDEO
SATELLITE RECEIVER MODULE (Continued)
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove instrument panel silencer (Refer to 23
- BODY/INSTRUMENT
PANEL TOP COVER - REMOVAL).
(3) Remove mounting fasteners (Fig. 13).
Fig. 13 SATELLITE RECEIVER MODULE
1 - SATELLITE RECEIVER MODULE
2 - FRONT PASSENGER DOOR
(4) Pull satellite receiver module inboard, and then
downward to remove from upper retaining clips.
(5) Disconnect wiring harness connectors.
(6) Remove satellite receiver module from vehicle.
INSTALLATION
(1) Install the satellite receiver module to the vehi-
cle.
(2) Connect the wire harness connectors.
(3) Push the module upward, and then outboard to
install into upper retaining clips.
(4) Install mounting fasteners.
(5) Install instrument panel silencer (Refer to 23 -
BODY/INSTRUMENT
PANEL TOP COVER - INSTALLATION).
(6) Connect the battery negative cable.
SPEAKER
DESCRIPTION
There are four different system combinations avail-
able on the LH models. They are a Base, Midline,
Infinity l, and Infinity ll system.
BASE SYSTEM
The Base System includes:
• Two 6.5 inch round, full-range speakers in the
front doors.
PANEL/INSTRUMENT
PANEL/INSTRUMENT
• Two 6 x 9-inch, full-range speakers mounted in
the rear shelf panel.
MIDLINE SYSTEM
The Midline System includes:
• A compact 120 watt power amplifier with four
output channels.
• Two 2.5 inch, round single-cone speakers in the
lower front corners of the front door windows.
• Two 6.5 inch, round single-cone speakers in the
front doors.
• Two 6 x 9-inch, full range speakers mounted in
the rear shelf panel.
INFINITY l SYSTEM
The Infinity l System includes:
• A 240 watt Infinity power amplifier with six out-
put channels
• One 2.5 inch, round single-cone, spatial imaging
speaker in the center of the instrument panel.
• Two 2.5 inch round, single cone, spatial imaging
speakers in the lower corners of the front door win-
dows.
• Two 6.5 inch, round single-cone speakers in the
front doors.
• Two 6 x 9-inch, single-cone speakers mounted in
the rear shelf panel.
INFINITY ll SYSTEM
The Infinity ll System includes:
• A 360 watt power amplifier with nine output
channels, one for each speaker location.
• One 2.5 inch, round single-cone, spatial imaging
speaker in the center of the instrument panel.
• Two 2.5 inch round, single cone, spatial imaging
speakers in the lower corners of the front door win-
dows.
• Two 6.5 inch, round single-cone speakers in the
front doors.
• Two 6 x 9-inch, single-cone speakers mounted in
the rear shelf panel.
• Two 2.5 inch, round speakers mounted in the
rear doors.
OPERATION
Two wires connected to each speaker, one feed cir-
cuit (+) and one return circuit (–), allow the audio
output signal electrical current to flow through the
voice coil. For complete circuit diagrams, refer to the
appropriate wiring information. The wiring informa-
tion includes wiring diagrams, proper wire and con-
nector repair procedures, details of wire harness
routing and retention, connector pin-out information
and location views for the various wire harness con-
nectors, splices and grounds.
LH