Installation Of The Dc Sparker - HAMPTON BAY H27 Owners & Installation Manual

INSTALLATION

Installation of the DC Sparker

for the H27 Unit Only:
1) Remove the control panel by unscrewing
the 2 screws.
2) First, remove the Piezo Ignition Wire
from the Piezo Ignitor. Then remove the
Piezo Ignitor from the control panel.
3) Plug up the Piezo hole with the plastic
bushing.
4) Attach the DC sparker generator
connector to the valve with a screw.
32
5) Remove the stove's rear panel by unscrew-
ing the two screws.
6) Attach the ground wire to the grounding
stud.
7) Attach the ground wire to the grounding
stud.
8) Attach the Piezo ignition wire to the DC
Sparker.
9) Insert both the ground wire and the DC
sparker generator wire through the hole
of the DC spark heat shield.
10) Install the plastic bushing over the
outside of the hole.
11) Attach the ground wire to the DC spark
mounting bracket.
12) Attach the DC sparker generator wires to
the DC sparker.
13) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker
Box will need to be replaced annually.
Battery
Compartment
Piezo
Ignitor
14) Attach the heat shield to the DC sparker,
then mount onto the stove using the
velcro already attached to the DC
Sparker mounting bracket.
Note: We recommend attaching the
DC sparker box to the bottom rear of
the stove (or place this in a convenient
location, away from the heat source).
15) Tie up the loose wire with the wire clip.
®
Hampton H27 Direct Vent Freestanding Gas Stove