Table of Contents
Advertisement
®
SuperLite
17B
The diver must hold the helmet down while the clamp
is swung to their right to fully engage it against the
bottom of the helmet. Note how the tender is support-
ing the clamp mechanism with their left hand.
The clamp is swung to the diver's left. Once it passes
"over-center" it will close easily,
40
The pull pin must properly engage the bail on the
neck clamp.
The safety pin must be installed prior to every dive.
The tender next grasps the handle on the neck clamp
assembly and swings it to the diver's right. This ac-
tion will open the clamp fully.
While the diver holds the helmet down, push up on
the neck clamp assembly until the clamp is complete-
ly seated against the bottom of the helmet. DO NOT
USE THE HANDLE AS A LEVER TO LIFT THE
CLAMP. This will damage the clamp mechanism.
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
Advertisement
Table of Contents
