Table of Contents
Advertisement
WARNING
The exhaust valves must be correctly
installed in the exhaust valve inserts or
they will not seal correctly. This could
lead to a backflow of water into the hel-
met, which could expose the diver to any
contaminants that are in the surrounding
water. Depending on the contaminants,
this could lead to serious personal injury
or death.
The whiskers must be aligned properly on the exhaust main
body.
on the bottom of the exhaust whiskers should be 5/16"
behind the parting line on the main body.
7) Repeat this procedure for the port side.
8) Place whisker clamps around the grooves on each
of the two whiskers. Before doing the final tightening
Note the step on the inside of the whisker clamps. These must
be oriented in the correct position to retain the whisker wings
properly.
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
Note the correct alignment of the mold line that spans the
whiskers and the exhaust main body.
of the clamps, make sure that parting line on bottom
of the whisker wings is 5/16" behind the parting line
on the main body, and the clamps are positioned
properly on the body.
The correct orientation of the whiskers relative to
the exhaust main body are as shown in the photo
here. Tighten the screws that hold the clamps until
the screws are snug. The threaded ends of the screws
should be at least flush with the outer edge of the nut
that holds them. Do not overtighten.
®
SuperLite
17B
101
Advertisement
Table of Contents
