Table of Contents
Advertisement
7.8.9 Reassembly of the SuperFlow
Demand Regulator
NOTE: Use the blow-apart in the back of the
manual to help ensure correct assembly.
1) Install the new exhaust valve into the regulator and trim
off any excess stem that may interfere with the movement
of the lever or inlet valve.
2) Install the spring and washer on the inlet valve.
3) Press the head of the inlet valve into the castle wrench
(Part #525-618). Place the spring, and washer on the inlet
valve shaft then insert it into the inlet tube in the regula-
tor body.
4) Push in on the castle wrench compressing the spring
while forcing the threaded portion of the shaft stem into
the interior of the regulator body. Place the washer and
the spacer over the end of the inlet valve stem.
As an alternate procedure, the washer and spacer may be
placed in the recess in the inside of the regulator body
before inserting the inlet valve stem.
SuperFlow
regulator body with roller lever assembly
®
and inlet valve.
Washer
Inlet valve
Inlet nipple "B"
Jam Nut
Inlet nipple
"A"
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
350
®
Spacer
Regulator
Piston
body
Spring
Exhaust
Washer
Valve
Trim any excess exhaust valve tail from the interior of the
5) Using the socket wrench nut driver from the tool kit,
run the nut (126) onto the inlet valve stem approximately
1 1/2 to 2 turns, leaving enough slack to allow installation
of the lever. With the inlet valve pressed in, the washer
and spacer must be loose on the inlet valve stem so that
the lever can be installed.
Adjustment
shaft
Diaphragm
Nut
Spacer
Roller lever
SuperLite
regulator.
Adjustment
knob
Retaining
pin
Packing
nut
Retaining clip
Clamp
Cover
®
17B
87
Advertisement
Table of Contents
