Table of Contents
Advertisement
®
SuperLite
17B
9.4 Weld Lens & Weld Shield
Assemblies
Tools Required:
3/8 " Open End Wrench
1/4 " Flat Blade Attachment on Torque Screwdriver
1) Remove the two plug screws from the port retainer. Refer
to the drawing included with the weld lens or weld shield
assembly kit for the remainder of the location numbers.
Remove the two plug screws from the face port.
Insert the screws in the mount ears of the weld lens
assembly.
2) Insert the screws through the spacer washers and then
through the mount ears.
3) Mount the weld lens assembly with the rubber bumpers
facing the inside of the helmet. The Weld Shield mounts
with the lens and spring side facing inside the helmet.
4) Install and tighten the two mount bolts into the port
retainer.
152
5) On the Weld Lens Assembly, tighten the two lock nuts
on the ends of the hinge studs so that the assembly can
be flipped up, but will not fall down from its own weight.
The Weld Shield Assembly comes pre-tightened from the
factory and should not need any adjustment.
The screws that secure the weld shield insert as
shown here.
Tighten the screws that secure the assembly to the
port retainer.
Proper installation of the weld shield.
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
Advertisement
Table of Contents
