Table of Contents
Advertisement
®
SuperLite
17B
Pull the rubber cover over the regulator body.
Install the PVC tube at the regulator.
Install the bent tube at the side block.
150
6) To install the rubber regulator cover, slide it over
the bent tube assembly and stretch it over the regulator
adjustment knob.
7) Install the rubber side block cover. Start by inserting the
non-return valve through the square hole on the back side
of the cover. All the other holes will then line up correctly.
8) Slide one of the PVC flanges (Part #520-046) over the
bent tube and insert it into the regulator shroud.
9) Slide the corrugated tube over the bent tube.
10) Install the second PVC flange in the side block shroud
(1/4 of the flange should still show).
11) Attach the side block end of the bent tube to the side
block assembly and using a torque wrench torque to 100
inch pounds.
12) Re-torque jam nut using a torque wrench torque to 40
inch pounds.
13) Stretch the corrugated tube over PVC flanges on the
regulator and the side block.
14) Install the tie wraps on the corrugated tube over the
PVC stiffeners and tighten, then trim excess tail off.
15) Trim the excess ends from the tie wraps.
16) Reinstall the free flow knob, spring, and lock nut.
17) Reinstall the EGS (Emergency Gas Supply) knob,
spring, and nut.
18) Reinstall the one-way valve and using a torque wrench
tighten to 150 inch pounds.
Completed instal-
lation of the hot
water shroud
on the Super-
Lite
-17.
®
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
Advertisement
Table of Contents
