Table of Contents
Advertisement
®
SuperLite
17B
6) Check the roller lever. The lever legs MUST be parallel
to each other and free of any nicks or burrs. Check them
with a straight edge and align them if necessary by care-
fully bending them with pliers. With the inlet valve stem
depressed into the regulator body, insert the lever legs
between the washer and spacer then release the pressure
on the inlet valve.
7) Hold the inlet valve with the castle wrench so that it
cannot rotate, tighten the nut until three threads are visible
past the nut. This will be close enough for initial set up.
8) While holding the lever down, install the inlet nipple
with its O-ring into the regulator body. Using the torque
wrench, tighten the inlet nipple to 40 inch pounds.
9) Lightly lubricate the piston and spacer. Install the
piston, spring set and spacer into the adjustment tube of
the regulator body, as shown in the blow-apart drawing.
10) Reassemble the adjustment knob assembly; lightly
lubricate the new O-ring then install the new washer,
O-ring on the adjustment shaft.
11) Slide the packing nut onto the adjustment shaft, then
slip the knob onto the end of the shaft. Hold the shaft and
rotate the knob until the pinholes line up.
Shaft
Spacer
Piston
88
Packing nut
Washer
O-ring
Spring set
Regulator body
Adjustment end of the SuperFlow
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
CAUTION
Be sure that the washer and spacer that
are installed on the inlet valve shaft are
installed in the correct order. If they are
not, the regulator will not perform prop-
erly.
Make sure the washer and o-ring are properly installed on
the adjustment shaft.
Use the inlet valve holder from the regulator tool kit to
accurately align these holes.
Adjustment
knob
regulator.
®
Retaining Pin
Advertisement
Table of Contents
