Table of Contents
Advertisement
®
SuperLite
17B
RTV (silicone sealant) is used to seal the weights to
the helmet shell.
5) Install the screws and washers and tighten using
a torque wrench with screwdriver adapter to the re-
quired torque values (35 inch pounds). Make sure all
snap tabs, the chin strap, and the earphone retainer
clips are in their original positions.
6) Wipe off all excess RTV that has oozed out from
under the weights.
7) Allow 24 hours for the sealant to cure before using
the helmet.
Alignment
screw
Alignment
sleeve
Starboard
weight
124
ness. They can also cause long term
damage to body tissue. Read and follow
all precautions listed on the silicone seal-
ant tube and Material Safety Data Sheet.
Rear weight
Snap tab
Chin strap
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
WARNING
Use silicone sealant
in a well ventilated
area. Do not breathe
the fumes from un-
cured silicone seal-
ant. These fumes are
dangerous and can
cause unconscious-
Handle
Port
weight
Weights and associated hardware on
the SuperLite
-17B
®
Advertisement
Table of Contents
