Table of Contents
Advertisement
Lift the helmet over your head.
The rear hinge tab must engage the alignment sleeve.
WARNING
If the hinge tab is not mounted on the
alignment sleeve correctly, the yoke/neck
clamp assembly could come off. Helmet
flooding may occur. Drowning and death
may result if the helmet floods.
© ⅯⅯⅩⅡ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 120613005
Close-up detail of hinge tab engaging alignment
sleeve.
replace it at the earliest opportunity.
Tilt your head back and push the entire yoke/neck
clamp assembly backwards on your neck. This is to
engage the hinge tab on the alignment sleeve. The
front edge of the neck clamp should be under and past
the front edge of the helmet. Keep your head tilted
back, and lift the front of the helmet up with one hand.
The tender must locate the rear hinge tab on the back
of the yoke. Lift the rear hinge tab out away from the
helmet and up until it can slide over the alignment
sleeve on the back of the helmet. Slide the tab over
the sleeve.
®
SuperLite
17B
39
Advertisement
Table of Contents
