Cd-Rom/Dvd Or Dat Drive (Netra Ct 800 Server Only) - Sun Microsystems Netra ct Service Manual

Note that in the sample feedback above, the Type column for the lower hard disk
drive (c0::dsk/c0t1d0) is now disk, and the Occupant column now shows it as
configured.
You can also use the hard disk drive (HDD) LEDs on the system status panel to
verify that the hard disk drive has been activated (
to Remove LED (
OFF, indicating that the hard disk drive has been activated.
10. If your hard disk(s) are under the control of RAID software, perform the
necessary steps to bring the disks online.
11. Perform any other necessary software procedures on the hard disk drive to bring
it online, including mounting the partitions and creating filesystems.
7.2 CD-ROM/DVD or DAT Drive (Netra ct
800 Server Only)
This section tells you how to replace a CD-ROM/DVD or Digital Audio Tape (DAT)
drive in a Netra ct 800 server. CD-ROM/DVD and DAT drives are referred to as
removeable media drives. The removeable media drives are hot-swappable
components. Note that internal removeable media drives are not available for the
Netra ct 400 server.
Following are the SCSI IDs for the devices used in the removeable media module:
CD-ROM/DVD—SCSI ID 6
DAT—SCSI ID 5
If you are removing and replacing a faulty removeable media drive in the server,
first to go "Removing a CD-ROM/DVD or DAT Drive" on page 7-9, then go to
"Installing a CD-ROM/DVD or DAT Drive" on page 7-11.
If you are installing a new removeable media drive in the server, go to "Installing
a CD-ROM/DVD or DAT Drive" on page 7-11.
7-8 Netra ct Server Service Manual • February 2001
) on the system status panel for the hard disk drive should go
on page 7-6). The Okay
FIGURE 7-2