Removing The Id Board From The Sun Fire E4900 System; Installing The Id Board In The Sun Fire E4900 System - Sun Microsystems Fire E6900 Systems Service Manual

5. Enter the system data information into the new ID board.
Refer to the Sun Fire Midrange Systems Platform Administration Manual, "Removing
and Replacing Boards" chapter.
11.3.3 Removing the ID board From the Sun Fire E4900
System
1. Halt the Solaris operating environment in each domain and power down the
entire system.
Refer to the Sun Fire Midrange Systems Platform Administration Manual for complete
procedures for powering off the system.
2. Attach a wrist strap or foot strap. Connect the ESD jack from the system to your
wrist strap or foot strap. Place a grounded ESD mat close to the system.
3. At the rear of the system, remove I/O assembly IB8 and the upper System
Controller board.
See Chapter 9
procedures.
4. Reach into the opening created by removing the boards and grasp the ID board by
the edges and remove it from the centerplane.
11.3.4 Installing the ID board in the Sun Fire E4900
System
1. Attach a wrist strap or foot strap. Connect the ESD jack from the system to your
wrist strap or foot strap.
2. Reach into the opening created by removing the boards and connect the ID board
to the connectors on the centerplane.
3. Replace the top System Controller board and the top I/O assembly.
See Chapter 9
replacement procedures.
4. Power on the system.
Refer to the Sun Fire Midrange Systems Platform Administration Manual for complete
procedures for powering on the system.
11-26 Sun Fire E6900/E4900 Systems Service Manual • May 2006
for I/O assembly, and
for I/O assembly, and
Chapter 7 for System Controller board removal
Chapter 7 for System Controller board