What To Do If - John Lewis JLBIOS609 User Information

What to do if ...

Problem
The oven does not heat up
The oven lighting is not
operating
The oven is not heating up.
Time is lit.
The pyrolysis function is not
working ("C1" is shown in
the time display)
The pyrolysis function is not
working ("C3" is shown in
the time display)
F2 appears in the clock
display
An error code not listed
above appears in the time
display
Possible cause
The oven is not switched on
The clock is not set
The required settings have not
been set
The oven's automatic cut-out has
been triggered.
The fuse in the house's electrical
wiring (fuse box) has been
tripped
The oven bulb is faulty
Demo mode is on.
Side rails/oven shelf runners have
not been removed
Door not properly closed or
door lock defective
Door not properly closed or
door lock defective
Fault in the electronics
51
Remedy
Switch the oven on
Set the current time on the clock
Check the settings
See Automatic cut-out
Check fuse. If the fuses trip repeatedly,
please call an authorised electrician
Change the oven bulb
Keep Time functions button pressed
for 2 seconds, then within 2 seconds
press and hold Time functions and
buttons for 2 seconds
Remove side rails/oven shelf runners
Close door properly
Close door properly;
Turn the appliance off and on again via
the house fuse or the safety switch in
the fuse box;
If displayed again, please contact the
Customer Care Department
Switch off the appliance via the house
fuse or the safety switch in the fuse
box and switch it on again
If displayed again, please contact your
local Service Force Centre