Table of Contents
Advertisement
FOR 83", 83-1/2"
• This kit provides optional side trim pieces for the
original grille frame to fit 83", 83-1/2" or 84-1/2"
AND 84-1/2"
installation heights.
INSTALLATION
HEIGHTS
To change grille panel size:
• Determine the installation height by measuring the
enclosure from the floor to the underside of soffit.
When there is no soffit, measure to the top of
adjacent cabinets.
• Adjust refrigerator case trim to desired height. See
Production Installation.
• Select the side trim pieces for your installation height.
Installation
Height
83"
83-1/2"
84-1/2"
A. Locate original grille panel frame supplied with the
refrigerator.
• Remove 8 screws (two on each corner) as
illustrated. Discard original side trim pieces.
B. Select correct size of side trim pieces (3 sets
provided).
• Secure new side trim pieces to original bottom trim.
C. Remove barrel nuts from original side trim pieces (2
each side).
• Re-install the barrel nuts on the new side trim pieces
you have selected.
D. Slide custom panel into front slots.
• Secure the top trim piece to the frame with "L"
brackets and screws.
Panel
Side Trim
Panel
Width
Lengths
Height
35"
8-1/4"
8"
35"
8-3/4"
8-1/2"
35"
9-3/4"
9-1/2"
Barrel
Discard
Nuts
Side Trim
Pieces
ZG2 Trim Kit
Grille Panel Frame Adjustment
E. Mount the assembled panel by dropping into slots
on the case trim.
1-1/2"
min.
gap
Important: Maintain 1-1/2" min. gap between top of doors and
bottom of grille panel.
Note: ZG1 Grille Panel Kit is available for models
produced before January 1997. Panel sizes for ZG1 and
ZG2 are the same. The ZG1 kit can be ordered from your
Monogram dealer.
26
Advertisement
Table of Contents
