Legend Series Control; Initial Start-Up; Temp Set; Time - Master Spas LEGEND XTREME SERIES Owner's Manual

LEGEND SERIES CONTROL
LSXIOSO, LS850, LS800, LS750, LS700, LS650, LSX MODELS
Circ Operation 3-Pump Version
Initial Stait-up
When your spa is first actuated, it will go into Priming mode. Indicated by Pr on the display. The Priming mode will
last for less than 5 minutes and then the heater will begin to heat the spa and maintain the water temperature in the
Standard mode.
LEGEND SERIES
Your system has a 24-hour circ pump. The circ
pump runs continuously. The ozone generator runs
during the first half of each hour, except when the
ozone generator turns off for an hour due to a
Therapy button being pressed.
Temp Set (80°F - 104°F I 26°C - 40°C)
The start-up temperature is set at 100°F/37.5°C. The
last measured temperature is constantly displayed on
the LCD.
Note that the last measured spa temperature
displayed
is current only when the circ pump has been
running for at least 2 minutes.
Press the "Waim" or "Cool" button once to display
theset temperature. Each time either button is pressed
again, the set temperature will increase or decrease
depending on which button is pressed. After three
seconds, the LCD will automatically display the last
measured spa temperature.
Time
Press this button once to display the cunent time of
day.
When time hasn 't been programmed, the TIME icon
flashes . See page 16 for instructions on "Setting the
Time."
- 12 -
Therapy 1
Press the "Therapy l " button once to tum pump 1 on
or off, and to shift between low and high speeds if it is
a two-speed pump. If left running, the low speed turns
off after 4 hours and the high speed turns off after 30
minutes.
Therapy 2
Press the "Therapy 2" button once to turn pump 2 on
or off, and to shift between low and high speeds if it is
a two-speed pump. If left rmming, the pump will tum
off after 30 minutes.
Therapy 3
Press the "Therapy 3" button once to tum pump 3 on
or off. If left rmming, the pump will turn off after 30
minutes.
Invert
Press the " Invert" button to reverse the display if you
are looking at it and it appears upside down.