Table of Contents
Advertisement
Power up the System
Once you have all cables connected properly, you are ready to turn the system on as follows:
1. Plug in the power cord to an AC outlet.
2. Locate the on/off switch on the back of the unit and click the switch to On.
The unit will power up and the LEDs will flash and turn off; the power LED will remain lit. For
information about the LEDs, see
Chapter 2: Hardware
Components.
Once the unit is powered up, you are ready to assign an IP address. See the following section
Assign
IP
Address.
Chapter 3: Installation
3-12
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Advertisement
Table of Contents
