Power Up The System - Quintum Tenor AS Product Manual

Chapter 3: Installation/Basic Troubleshooting

Power up the System

Once you have all cables connected properly, you are ready to turn the system on as follows:
1. Plug in the AC power cord adaptor to an AC outlet.
2. Locate the on/off switch on the back of the unit and click the switch to On.
The unit will power up and the LEDs will flash and turn off; the power LED will remain lit. For
information about the LEDs, see
Once the unit is powered up, you are ready to assign an IP address. See the following section
.
IP Address
3-8
Chapter 2: Hardware Components.
Change
P/N 480-0059-00-00