Quintum Tenor BX Product Manual page 48

you are directly connected to the unit. To connect to the Tenor BX serial port, locate a workstation
(PC) close to the Tenor BX unit. Connect as follows:
1. Insert one end of the DB-9 serial null modem cable into the Tenor BX's serial port.
2. Insert the other end of the DB-9 serial cable into your workstation's Com/serial port.
Once the cable is connected and the Tenor BX is powered on, open a HyperTerminal session (or
other terminal emulation program) as follows:
3. Click Start > Programs > Accessories > Communications > HyperTerminal. The HyperTermi-
nal window will be displayed.
4. Click on Hypertrm.
5. Enter a connection description (i.e., name for each unit such as Tenor BX 1).
6. Click Ok.
7. Choose a connection port (on your PC) from the Connect Using drop down list box (i.e., Direct
to Com 1). Click Ok. The Com 1 properties window will be displayed.
8. From the Bit Per Second drop down list box, choose 38400.
9. From the Data Bits drop down list box, choose 8.
10.From the Parity drop down list box, choose None.
11.From the Stop bits drop down list box, choose 1.
12.From the Flow Control drop down list box, choose None.
13.Click on Call>Call. A connection to the Tenor BX will be established.
14.Enter a login name. The default login name is admin.
15.Enter a password. The default password is admin. Questions about the unit will scroll on the
screen.
Steps 16-18 are used for first time assignment of IP address.
NOTE:
16.For IP address, enter the IP address for the Tenor BX unit.
17.For Subnet Mask for LAN prompt, enter the subnet mask.This address is used to differentiate the
network portion of the IP address from the host portion of the IP address.
18.For Default Gateway prompt, enter the IP address for the default gateway (router) which routes
packet data outside of your LAN.
The Tenor BX will reboot automatically.
Chapter 4: Configuration/Monitoring
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
4-5