EUROCOM M590K User Manual page 124

Troubleshooting
Problem
The computer feels too
hot.
Nothing appears
screen.
8
No image appears on
the external monitor I
have plugged in and
powered on.
8 - 8 Problems & Possible Solutions
Make sure the computer is properly ventilated and the vents/fan intakes are not blocked. If this
doesn't cool it down, put the system into Hibernate mode or turn it off for an hour. Make sure the
computer isn't sitting on a thermal surface (see
using the correct adapter.
Make sure that your notebook is completely powered off before putting it into a travel bag (or any
such container). Putting a notebook which is powered on in a travel bag may cause the vents/fan
intakes to be blocked.
on The system is in a power saving mode. Toggle the sleep/resume key combination, Fn + F4 (see
"Sleep Button" on page 3 -
\
The screen controls need to be adjusted. Toggle the screen control Fn + F8/F9 key combinations
(see Table 1 - 4, on page 1 -
plugged in and turned on. You should also check the monitor's own brightness and contrast
controls.
The computer is set for a different display. Toggle the screen display key Fn + F7 combination
(see Table 1 - 4, on page 1 -
The screen saver is activated. Press any key or touch the TouchPad.
You haven't installed the video driver and configured it appropriately from the Control Panel. See
"What to Install" on page 4 - 1
Driver Controls" on page B - 1
Possible Cause - Solution
"Overheating" on page 1 -
8).
8). If you're connected to an external monitor, make sure it's
8). If an external monitor is connected, turn it on.
for instructions on installing the driver, and see
for instructions on configuring the video driver.
9). Make sure you're
"NVIDIA Video