Decommissioning; Disassembly; Packaging; Storage - SMA SUNNY MINI CENTRAL 6000TL Installation Manual

Decommissioning

10 Decommissioning
10.1 Disassembly
1. Open the Sunny Mini Central as described in section 7.1 „Opening the Sunny Mini Central"
(46).
2. Remove all connector cables from the Sunny Mini Central.
3. Close the Sunny Mini Central with the six screws and the corresponding washers.
4. Remove both screws on the left and right side of the
Sunny Mini Central that attach it to the wall
mounting bracket.
5. Disconnect the anti-theft protection, if applicable.
6. Remove the Sunny Mini Central upwards in a
vertical position from the wall mounting bracket.
7. When transporting the Sunny Mini Central, use the
ergonomic handles at the top and bottom at the
sides of the Sunny Mini Central (A) or the housing
opening, for example, by sliding a steel bar
through it (B) (diameter max. 30 mm).
10.2 Packaging
If possible, always pack the Sunny Mini Central in the original packaging. If this is no longer
available, a similar box can be used which can withstand the weight of the Sunny Mini Central
(35 kg), has a handle system, and can be closed fully.
10.3 Storage
Store the Sunny Mini Central in a dry place where ambient temperatures are always between
-25 °C and +60 °C.
10.4 Disposal
Dispose of the Sunny Mini Central at the end of its service life in accordance with the disposal
regulations for electronic scrap which apply at the installation site at that time. Alternatively, send it
back to SMA with shipping paid by sender, and labeled "ZUR ENTSORGUNG" ("for disposal")
(contact: see Page 62).
58 SMC6-8TL-IEN093231
SMA Solar Technology AG
A
Installation Guide
B