Cleaning The Handle Covers - SMA SUNNY MINI CENTRAL 6000TL Installation Manual

Maintenance
4. Check the fansair-flow.'
The Sunny Mini Central sucks air in from underneath and then blows it back out on the upper
sides. Listen for any unusual noise, which could indicate incorrect installation or that the fans are
faulty.
5. After checking the fans, remove the jumper. Open and close the Sunny Mini Central as
described in section 7 „Opening and Closing" (46).
8.1.3 Cleaning the Handle Covers
The Sunny Mini Central sucks air in from underneath via the fans and blows it out again at the top on
both sides via the handle covers. Clean the handle covers, if they are dirty. Proceed as follows:
1. Remove the handle covers.
Insert your finger above in the space between the
handle cover and the housing and remove the
handle covers to the side.
2. Clean the handle covers with a soft brush, a paint
brush, or compressed air.
3. Fasten the handle covers back onto the Sunny Mini
Central.
The handle covers must be attached according to
the inside inscription ("links/left" and
"rechts/right").
NOTICE!
Insects entering the Sunny Mini Central can damage the device!
• The handle covers must not be removed permanently, because otherwise the device
is not protected against the entrance of insects!
52 SMC6-8TL-IEN093231
SMA Solar Technology AG
Installation Guide