Display - SMA SUNNY MINI CENTRAL 6000TL Installation Manual

SMA Solar Technology AG
6.1 Display
Grid Feeding
After fault-free grid connection of the Sunny Mini Central, it takes approximately one minute until the
following display messages are shown alternately. The display messages shown before that only have
the purpose of indicating the initialization of the Sunny Mini Central and the process of controlling
whether the power supply requirements are fulfilled.
1. The energy generated today and the current
operating mode are displayed first.
2. The current feed-in power and the PV voltage are
displayed after 5 seconds or when you tap the
housing cover.
3. After a further 5 seconds, or when you tap again,
the total energy produced and the time the Sunny
Mini Central has been connected to the grid are
displayed.
4. Then the cycle begins again.
Disturbance
1. In case of a fault, the message "Disturbance" is
shown in the status bar.
2. The exact failure message follows.
For example, if the grid fault message shown here
is displayed immediately after connection, it may
be due to the fact that the AC wire is not correctly
connected or the circuit breaker is not switched on
yet.
3. If a measured value, which is not standard-
compliant, is responsible for the failure, then the
value measured at the time of the failure is
displayed. If another measurement is possible, the
current value is displayed in the second line.
Please refer to the provided operating manual of the Sunny Mini Central to read the exact
explanations for the error and status messages!
Installation Guide
Commissioning
SMC6-8TL-IEN093231 41