Completing Installation; Software - Toshiba SD-W1101 Hardware Instruction Manual

COMPLETING INSTALLATION

After you have connected all the necessary cables, you can push the
DVD-RAM completely into the slot. There are 8 screw holes on the
SD-W1101/SD-W1111 that are used to mount the DVD-RAM into
your computer, 4 on the bottom and 2 on each side. Use either the 4
bottom screw holes or the 4 side screw holes, depending on your
computer's installation requirements. The screw length should be more
than 2.5mm and not exceed 3.5mm (measured from outside surface of
side or bottom of DVD-RAM to tip of screw). A clearance of 5mm
should surround the DVD-RAM drive to allow for adequate circula-
tion. A .9mm clearance should be maintained around the top cover in
order to secure absorbing shock and vibration. Replace the computer's
cover, and replace all outer screws.
Mounting Screw
M3
Mounting frame of
host computer
Surface of side or bottom
of DVD-RAM drive
2.5 - 3.5mm
Mounting DVD-RAM

SOFTWARE

In order for your computer to recognize the DVD-RAM, you must
install a DVD software driver. The software driver should have been
included with the drive, or if you are installing a DVD/MPEG card,
you should use the software driver that came with the card. See Page
23 for software installation instructions.
11
TOSHIBA SD-W1101/W1111 DVD-RAM Drive