Operating The Dvd Loading Tray - Toshiba SD-W1101 Hardware Instruction Manual

OPERATING THE DVD LOADING TRAY

To open the DVD loading tray, just press the Load/Unload button.
After inserting or removing a disc or recording cartridge, press the
Load/Unload button again.
Vertical Installations
If you are loading a disc into a DVD-RAM drive that has been mounted
vertically, perform the following procedures:
1. Locate the four sliding disc holders on the tray (see photo below
for location). You will only need to use three of these holders, the
two found on the bottom, and the upper rear (closest to drive)
holder. Using all four may cause the disc to not set properly in tray.
The vertical position of the drive (eject button up or down) deter-
mines which holders are used (see photo below).
14
TOSHIBA SD-W1101/W1111 DVD-RAM Drive
DVD Loading Tray