Related Manuals for Toshiba SD-R2612
Summary of Contents for Toshiba SD-R2612
- Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-R2612 CD-RW/DVD-ROM COMBINATION MOBILE DRIVE USER MANUAL...
-
Page 2: Table Of Contents
CONTENTS Introduction...1 Setup ...3 Using the CD-RW/DVD-ROM Combo Drive ...4 Troubleshooting...7 Specifications ...8 Drive Connectors...11... -
Page 3: Introduction
INTRODUCTION – SD-R2612 General Features CD-RW disc write/rewrite at 4X – 24X CD-R disc write at 4X - 24X 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time 130ms DVD-ROM (single) 130ms DVD-ROM (dual) 150ms DVD-RAM 250ms... - Page 4 Front Panel Figure 1.SD-R2612 CD-RW/DVD Combo Drive Front Panel Load disc using tray. Loading Tray Busy The LED lights green or amber when the drive is operating (LED is amber when drive is writing.) Indicator The Eject button is used to open the disc tray so you can install or remove a disc.
-
Page 5: Setup
Toshiba's SD-R2612 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site. -
Page 6: Using The Cd-Rw/Dvd-Rom Combo Drive
USING THE CD-RW/DVD-ROM Combo Drive – SD-R2612 Drive Operation Inserting Media To insert media perform the following steps: 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. - Page 7 The SD-R2612 DVD-ROM/CD-RW drive supports the current RPC phase 2 industry specifications. This means that when the DVD-ROM drive ships from the factory it is set to the region for which the Operating System was intended.
- Page 8 Handling Media DVD media is sensitive to dust and fingerprints. Carefully handle media by its edges only. If a DVD movie skips or hangs during playback, clean the media. Most DVD video playback issues are media- related and can be remedied by proper handling and care of media. Cleaning Media Try to avoid touching the read area (underside) of the disc as dirt and smears will degrade the disc accessing speed.
-
Page 9: Troubleshooting
TROUBLESHOOTING – SD-R2612 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, recognized Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is... -
Page 10: Specifications
SPECIFICATIONS –SD-R2612 General Interface: ATAPI Format Compatibility • CD-DA (Red Book) - Standard Audio CD & CD-TEXT • CD-ROM (Yellow Book Mode1 & 2) - Standard Data\ • CD-ROM XA (Mode2 Form1 & 2) - Photo CD, Multi-Session • CD-I /FMV (Green Book, Mode2 Form1 & 2, Ready, Bridge) •... - Page 11 Performance Transfer Rate DVD (Single) DVD (Dual) DVD+/-R DVD+/-RW DVD-RAM (Ver 2.1) CD-ROM/R (Read, Mode 1) CD-RW Read (Mode 1) Random Access Time CD-ROM CD-RW DVD (single) DVD (dual) DVD-R/+R DVD-RW/+RW DVD-RAM Data Error Rate DVD-ROM CD-ROM Data Buffer Reliability MTBF •...
- Page 12 DC Voltage and Current Requirements Physical Height Width Depth Weight Connectors IDE Interface Connector Regulatory The SD-R2612 DVD Writeable drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) •...
-
Page 13: Drive Connectors
Drive Connectors –SD-R2612 Figure 1.SD-R2612 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-R2612 CD-RW/DVD- ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Connector Limited KX14-50Series L or equivalent connector.