Unless otherwise stated in writing, non-Toshiba software is provided on an “as is” basis by Toshiba. Any service or repair for items not covered by this limited warranty shall be at Toshiba’s or its Authorized Service Partner’s rates and terms then in effect.
Page 4
THIS PRODUCT WILL BE UNINTERRUPTED OR ERROR FREE. IF THIS PRODUCT FAILS TO WORK AS WARRANTED ABOVE, YOUR SOLE AND EXCLU- SIVE REMEDY SHALL BE REPAIR OR REPLACEMENT. IN NO EVENT WILL TOSHIBA, ITS AFFILIATES OR SUPPLIERS BE LIABLE TO YOU OR ANY THIRD PARTY FOR ANY DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE PRODUCT.
Table of Contents Checking your Kit Packaging ... 1 System Requirements ... 1 Media Recommendations ... 1 Setting Jumpers ... 2 Placing DVD Writeable Drive inside your computer ... 2 Connecting Cables ... 3 IDE BUS (data) Cable ... 3 Power Cable ...
Congratulations on your purchase of a Toshiba DVD-R/-RW Combo drive and Kit. The following information will help you in the simple installation of your new DVD Writeable drive. CHECKING YOUR KIT PACKAGING Please unpack your DVD Writeable drive kit, and assure that you have the follow-...
The following steps must be performed to properly install your DVD Writeable drive. Set drive’s jumpers Connect audio cable Attach IDE BUS cable Connect power cable Mount DVD Writeable Drive Install Nero6 Ultra Edition Software SETTING JUMPERS The mode select jumpers are six (6) straight pins located on the rear of the DVD Writeable Drive.
2. If the DVD Writeable drive is replacing a CD-ROM, disconnect all connectors and remove the CD-ROM presently installed in your system. 3. Your Toshiba DVD Writeable drive can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.) 4.
Connect secondary IDE BUS cable to the DVD Writeable drive, assuring that pin 1 of the cable (side with red stripe) is connected to pin 1 on the drive. • If the DVD Writeable drive is the only drive connected on the secondary IDE BUS cable: connect drive to the last set of pins on IDE BUS cable.
Replace the computer cover and all outer screws. ATAPI CD/DVD Software Driver: Toshiba’s optical drives do not require any unique device drivers for Windows 98/ 2000/ME/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Windows 98/2000/ME/XP/NT operating systems support all Toshiba optical drives natively.
MEDIA After installing Nero6 OEM Suite 3 software your system is ready to use. Some important things to remember when using your DVD Writeable drive: Do not insert more than one CD or DVD disc into the drive at a time. Do not insert anything other than a CD or DVD disc into drive.
DVD WRITEABLE DRIVE FRONT PANEL The photo below illustrates the following features of the SD-R5272 DVD Writeable drive’s front panel: DVD WRITEABLE DRIVE BACK PANEL The photo below illustrates the following features of the SD-R5272 DVD Writeable drive’s back panel:...
SPECIFICATIONS DATA CAPACITY ROTATIONAL SPEED SUSTAINED DATA TRANSFER RATE ACCESS TIME (Typ.) DVD-RAM DATA BUFFER POWER SUPPLY MTBF DIMENSIONS (Wx H x D) WEIGHT MOUNTING ORIENTATION APPLICABLE WRITE DISC CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, APPLICABLE READ DISC DVD-ROM, DVD-RAM CD-ROM DVD (single) DVD (dual)