Table of Contents
Advertisement
COMPLETING INSTALLATION
After you have connected all the necessary cables, push the DVD-ROM
Mounting Screw
Mounting frame of
Surface of side or bottom
2.5 - 3.5mm
Software Driver: The Toshiba SD-M1202 DVD-ROM Drive is "plug n'
play." When you apply power to your computer and boot-up, it should
recognize the new hardware and prompt you in the installation of the
SCSI driver. If you don't have the SCSI driver, contact your SCSI host
adapter board manufacturer. After you have completed installing your
DVD-ROM, refer to REALmagic™ User's Guide to install DVD/MPEG-2
Playback Card.
DVD-ROM FRONT PANEL
The photo illustrates the following features of the SD-M1202 DVD-ROM
front panel:
DVD loading tray
Headphone jack
Volume control
Busy light
Eject button
Emergency eject hole (insert solid bar into hole, i.e. paper clip, and
push until tray opens)
6
M3
host computer
of DVD-ROM drive
completely into the computer's
drive slot. Mount drive accord-
ing to your computer's instruc-
tions. The screw length should
not exceed 3±0.5mm (measured
from outside surface of side or
bottom of DVD-ROM to tip of
screw). Replace computer cover
and all outer screws.
Advertisement
Table of Contents
