Installing Dvd-Ram; Installation Requirements; Installation - Toshiba SD-W1101 Hardware Instruction Manual

Installing DVD-RAM

B
efore you begin to install your DVD-RAM, make sure you
have the items listed below. Some of these items will
not come with your DVD-RAM. See your local computer
retailer to purchase them.

INSTALLATION REQUIREMENTS

DVD-RAM Software Driver ("Write DVD" should have been pro-
vided with you DVD-RAM)
SCSI Host Adapter Board (with interface software)
DVD/MPEG Card (optional)
SCSI Interface Cable

INSTALLATION

In order to install your DVD-RAM successfully, you will need to com-
plete the following steps:
Install SCSI adapter board in your computer system
(if not already installed).
Set jumper settings on DVD-RAM.
Install DVD-RAM inside your computer.
Using a SCSI cable, connect DVD-RAM to SCSI interface card.
Connect computer power cable to internal DVD-RAM drive.
Connect a sound cable to your DVD-RAM (optional).
Additional audio connections may be available when using a
DVD/MPEG Card (see MPEG card installation instructions).
Load DVD-RAM driver software.
TOSHIBA SD-W1101/W1111 DVD-RAM Drive
3