Table of Contents
Advertisement
3.2.5. Shock
(1) Operating (Read) ---------------------------------no hardware error
(2) Operating (Write) ----------------------------------no error
(3) Non-operating (with no disc mounted) -------no damage
(4) Drop (Packaged)-----------------------------------no damage
(a) Bulk Package (50 units/1 package)
(b) Bulk package (20 units/1 package)
3.3. Installation Conditions
This drive can be installed horizontally within an angle of • } 15 degrees, and vertically within an angle of
30/15 degrees. Refer to Figure 1 for details.
o
15
o
15
o
15
o
15
3.3.1. Equipment
(1) When installing this drive, use the two M2-P0.4 tapping holes on each side.
(2) The opposite surface of the bearing surface (on which the drive is fixed) must be flat so that the
drive fits evenly.
(3) The length of the screws must be within the designated values so the screws do not go protrude.
Refer to Figure 3 for outside dimensions.
(4) When fixing the drive, apply equal torque to tighten the four screws. The recommended
tightening level is 0.2N m.
----------------------------------no data loss
Horizontal Position
Figure 1 Mounting angle
7 / 28
2
14.7 m/s
[1.5 G] (Horizontal)
(Half sine wave 11 ms/10 s interval)
2
98 m/s
[10 G]
(Half sine wave 11 ms/10 s interval)
2
14.7 m/s
[1.5 G] (Horizontal)
2
7.8 m/s
[0.8 G] (Vertical)
(Half sine wave 11 ms/10 s interval)
2
490 m/s
[50 G] (Half sine wave 11 ms)
2
980 m/s
[100 G] (Half sine wave 3 ms)
0.4 m drop once (bottom side only)
0.6 m drop once for each 6 surface,
1-edge and 1-corner
o
30
o
15
o
15
o
15
o
15
Vertical Position
TS-L532A (SD-R6472) Rev.1.1
o
15
Advertisement
Table of Contents
