Related Manuals for Toshiba SD-M1711
Summary of Contents for Toshiba SD-M1711
- Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-M1711 DVD-ROM SCSI DRIVE USER MANUAL...
-
Page 2: Table Of Contents
CONTENTS Introduction...1 Setup ...3 Using the DVD-ROM Drive ...7 Troubleshooting...10 Specifications ...11 Drive Connectors...15... -
Page 3: Introduction
INTRODUCTION – SD-M1711 DVD-ROM Drive General Features Tray Loading Mechanism 3-way Disc Eject (eject button, software, emergency eject hole) Average Random Access Time CD-ROM 85ms 105ms DVD-RAM 170ms DAE (Digital Audio Extraction) Audio Capability MPC3 Compatibility Headphone Output Volume Control... - Page 4 • CD-R (Read) • CD-RW (Read) Front Panel Figure 1.SD-M1711 DVD-ROM Drive Front Panel Load disc using tray. Loading Tray When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it Busy Indicator attempts to locate the disc. One of the following will occur: •...
-
Page 5: Setup
SETUP – SD-M1711 DVD-ROM The following steps must be performed to properly install your drive: • Set DVD-ROM Drive Jumper Settings: SCSI ID, Parity, Termination, 512/2K, Power • Connect Audio Cable • Attach SCSI Interface Cable • Attach Power Cable •... - Page 6 If the DVD-ROM drive is replacing a CD-ROM or DVD-ROM, remove drive presently installed in your system. Your Toshiba DVD-ROM drive can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.) Carefully start sliding the DVD-ROM drive into the opening with the disc tray facing the front of the computer.
- Page 7 CDs on your computer, you will need to install a CD/DVD audio cable. Toshiba's DVD-ROM drives use a standard 4-pin audio cable that can be purchased from most local computer suppliers. The sound cable connects to your sound card...
- Page 8 Figure 7.Mounting Illustration Software Driver - Toshiba's optical drives do not require any unique device drivers for Windows '95/'98/2000/Me/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Windows '95/'98/2000/Me/XP/NT Operating Systems support all Toshiba optical drives natively If...
-
Page 9: Using The Dvd-Rom Drive
USING THE DVD DVD-ROM Drive – SD-M1711 Drive Operation Inserting a Disc - Horizontally To insert a disc into a drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's Loading tray by pressing the Eject Button. - Page 10 Removing a Disc To remove a disc from the DVD-ROM drive, perform the following steps: 1. Open the Loading Tray by pressing the Eject Button. 2. Grasp disc by edges, and lift out of loading tray. 3. Press Eject Button again to close Loading Tray. Usage Guidelines •...
- Page 11 Handling Media DVD media is sensitive to dust and fingerprints. Carefully handle media by its edges only. If a DVD movie skips or hangs during playback, clean the media. Most DVD video playback issues are media-related and can be remedied by proper handling and care of media. Cleaning Media Try to avoid touching the read area (underside) of the disc as dirt and smears will degrade the disc accessing speed.
-
Page 12: Troubleshooting
TROUBLESHOOTING – SD-M1711 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, recognized Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is constantly... -
Page 13: Specifications
SPECIFICATIONS –SD-M1711 General Interface SCSI Compatible DVD-ROM Standards Storage Capacities Performance Rotational Speed DVD-ROM single layer dual layer DVD-R/-RW (Ver 2.0) DVD-R (Ver 1.0) DVD-RAM (Ver 1.0) DVD-Video CSS-disc CD-ROM, CD-R/RW CD-DA Transfer CD-DA/Video CD DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) - Page 14 Data Transfer Rate DVD (Single) DVD (Dual) DVD-Video DVD-R, DVD-RW DVD-RAM ( Ver 1.0) CD (mode 1) CD-(mode 2) Burst (SCSI Interface) Sync Async Random Access Time DVD-RAM Data Error Rate Spin-up Time DVD-RAM (Ver 2.1) Data Buffer Reliability MTBF Power ON Hours ON/OFF Cycles Number of Access...
- Page 15 Environmental Ambient Temperature Operating Storage Shipping Temperature Gradient Operating Storage/Shipping Relative Humidity Operating Storage/Shipping Vibration Operating Non-operating Shock (Non-operating) Acoustical Noise Power DC Voltage and Current Requirements Idle (Laser ON, Motor ON) Continuous Read (Data/Audio) Standby (Laser OFF, Motor OFF) Random Access (average) Physical Height...
- Page 16 Lasers CD Laser Type Wave Length DVD Laser Type Wave Length Regulatory The SD-M1711 DVD-ROM drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) • CE standard • •...
-
Page 17: Drive Connectors
CAUTION: Severe damage to the Drive circuits may occur if power cable is plugged in upside-down with power ON Supplies Analog sound to your system Audio Connectors SCSI The SD-M1711 DVD drive is connected to your computer system through the SCSI connector. Connector... - Page 18 Table 1.Interface Pin Assignments SIGNAL NAME NO CONNECTION TERM POWER (+5v) SIGNAL NAME -DB0 -DB1 -DB2 -DB3 -DB4 -DB5 -DB6 -DB7 -DBP -ATN -BSY -ACK -RST -MSG -SEL -C/D -REQ -I/O...