Miscellaneous; Accessories; A Bare Disc Setting At Vertical Installation - Toshiba SD-W1111 Product Specification

Dvd-ram drive

Hide thumbs Also See for SD-W1111:

Table of Contents

TOSHIBA DVD-RAM SD-W1111

15. MISCELLANEOUS

Function setting jumper pins

Emergency eject tool

In case of using a bare disc (ex. DVD-ROM or CD-ROM) at vertical installation, use disc holders on

the tray. Please read the following explanations thoroughly at this time.

1. Draw three disc holders among the four holders on the tray, two pieces are both holders in down

side, one piece is on a rear part in upper side while made to vertical posture as follows.

(Note) Please use 3 pieces holders because the set of the disc becomes difficult when four disc

holders are drawn out.

2. Drawing out a disc holder (pull return) can be easily done with inserting a propelling pencil ahead

in the hole that is installed on the disc holder.

5 pieces.

1 piece.

Page 30

OD-A017-02

'99/06/26

Version

Product Specification

1.0

Table of Contents