Control Unit; External Equipment - Furuno FS-1575 Installation Manual

2. WIRING
2.3

Control Unit

Connect the Transceiver Unit to the Control Unit with the cable with the D-sub 15-pin connector
at both ends. Connect a single Control Unit to the CONTROLLER 1 port. (This port has priority
when two Control Units are connected.) Connect a No.2 Control Unit to the CONTROLLER 2 port.
Connect the handset HS-2003 to the HANDSET port at the rear of the Control Unit. For other
handset or microphone, connect to the HANDSET REAR port.
2.4

External Equipment

Connect cables for external equipment to the T-IF Board in the Transceiver Unit.
GNSS
This radiotelephone can receive the following sentences in IEC 61162-1 (ed.2nd) format. Use the
cable TTYCS-1/TTYCSLA-1 (or the equivalent) to connect the equipment to IEC 61162-1 of TB6
in the Transceiver Unit.
Data
Position info, Position fix
Time info
Alarm Unit IC-350
Connect the Alarm Unit IC-350 to TB7 in the Transceiver Unit with the cable TTYCS-4/TTYCSLA-
4 (or the equivalent).
Fabrication of TTYCS series
Braided shield
Make hole here, pull out core and
cut off inclusion.
L
8 - 10
60
Crimp-on
lug
Tape entire
shield
Sentence, priority order
GNS>GGA>RMC>GLL
ZDA>RMC
Sheath
40 20
Set this part in cable clamp.
20 30 20
Vinyl tape
25
Armor
FS-1575T
FS-2575T/FS-5075T
Length of "L"
190
120