Furuno FS-1575 Installation Manual page 28

See exploded view
below.
COAXIAL
CABLE**
Fixing plate
5. Check that the gasket is engaged to the posts on the casing then close the cover.
(Pictured: AT-5075)
* How to process the shield:
Solder vinyl wire to shield, fasten crimp-on
lug to vinyl wire, fasten crimp-on lug to the
"E" terminal.
For cable 05S0793 (five-pair cable), cut
unused wires and wrap them and the
shield with vinyl tape.
** How to fabricate the coaxial cable:
1. Remove sheath 50 mm.
2. Remove insulator 20 mm.
3. Make length of conductor 10 mm.
4. Cut shield to length of 5 mm and fix with
the fixing plate.
Antenna Coupler AT-5075, inside view
Post
20
2. WIRING
Connect shield*
to "E" terminal.
Locking wire saddle
SIGNAL CABLE
(See section 2.2.4
for how to fabricate.)
Be sure cable does not
touch resistors.
Crimp-on
Vinyl wire
lug
Solder
here.
Shield