Furuno FS-1575 Installation Manual page 32

4. Screw the plug assembly on the cable.
5. Solder the plug assembly to the braided shield through solder holes. Solder the contact sleeve
to the conductor.
6. Screw the coupling ring into the plug assembly.
7. Screw the plug into the WR1_ANT, WR2_ANT, R_ANT or T/R_ANT receptacle on the Trans-
ceiver Unit as applicable.
Sheath
10 mm 2 mm
Braided shield
2.2.4 5-pair cable
Fabricate the cable as shown below. Do not unravel the twisted wire pairs.
Sheath
Cut hole in shield.
(A) Remove sheath by approx.
15 cm (150 mm) and cut hole
in shield.
35 mm
Conductor
Insulator
Coupling ring
Paper tape
Inner shield
(B) Pull out paper tape and inner
shield from hole and cut them.
Shorten shield considering its
location in the transceiver.
Plug assembly
Solder both
sides of hole.
Tape entire shield
6 mm
Crimp-on lug
(C) Attach crimp-on lug* to shield.
Expose cores of wires approx.
6 mm. Tape wires and shield with
vinyl tape.
* Dimensions of crimp-on lug:
φ4.3
8.3 13.5
26.5
24
2. WIRING
Contact sleeve
Solder
here.
Cut
conductor
here.
Taping