Automatic Antenna Switch As-102 (Option) - Furuno FS-1575 Installation Manual

2. WIRING
2.6

Automatic Antenna Switch AS-102 (option)

Connect the SSB antenna to the ANT terminal, and use the antenna cable to connect the TRX
terminal and the Antenna Coupler (ANT terminal) as shown below. For the signal cable, connect
the DPYCY-1.5 (or DPYC-1.5) cable between the Transceiver Unit and the Automatic Antenna
Switch as shown below. For outside installation, follow the procedure in section 2.1.2.
DPYCY-1.5 (outdoor)
DPYC-1.5 (indoor)
to TB7 of T-IF Board (05P0861)
in Transceiver Unit
- #13: +
- #14: -
How to process the cable (example: DPYCY-1.5)
Use crimp-on
lugs, pre-attached
to terminal board
in Automatic
Antenna Switch.
ANT
+-
TRX
Ground
terminal
Protective ground wire
(IV-14sq, YEL/GRN,
local supply)
Tape around the armor.
Vinyl
sheath
Fix cable with cable gland
at vinyl sheath part
31
SSB antenna
Antenna cable
to Antenna coupler
(ANT insulator)