Initial Settings; How To Initialize The Control Unit And Transceiver Unit; How To Enter Mmsi - Furuno FS-1575 Installation Manual

3.

INITIAL SETTINGS

This chapter shows you how to enter the initial settings. A password is required to en-
ter the initial settings. Refer to FURUNO Information for the password.
3.1 How to Initialize the Control Unit and
Transceiver Unit
Turn on the power switch on the Control Unit. The equipment starts to update the soft-
ware, in the sequence shown below. When the procedure is completed, the radiotele-
phone screen appears.
INITIALIZING ..
PLEASE WAIT
3.2

How to Enter MMSI

1. Turn on the Control Unit. Open the Transceiver Unit and press and hold the Reset
switch S1 (approx. 5 seconds) on the T-IF Board (05P0861) until the menu shown
below appears on the Control Unit.
*** FS-Controller Download ***
From ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erasing ... xx%
Approx.
70 s
later
xxxxxxxxxxxxx=Program version no.
*** FS-Controller Download ***
From ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erase completed.
Writing... xx%
Push Reset switch
S1 until the menu
shown below appears
on the Control Unit.
Lock icon
(brown)
3-1