Initial Settings; How To Initialize The Control Unit And Transceiver Unit; How To Enter Mmsi - Furuno FS-1575 Installation Manual

Ssb radiotelephone
Hide thumbs Also See for FS-1575:
Table of Contents

Advertisement

3.

INITIAL SETTINGS

This chapter shows you how to enter the initial settings. A password is required to enter the initial
settings. Refer to FURUNO Information for the password.
3.1
How to Initialize the Control Unit and
Transceiver Unit
Turn on the power switch on the Control Unit. The equipment starts to update the software, in the
sequence shown below. When the procedure is completed, the radiotelephone screen appears.
INITIALIZING ..
PLEASE WAIT
3.2

How to Enter MMSI

1. Turn on the Control Unit. Open the Transceiver Unit and press and hold the Reset switch S1
(approx. 5 seconds) on the T-IF Board (05P0861) until the menu shown below appears on the
Control Unit.
*** FS-Controller Download ***
From
ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erasing ... xx%
Approx.
70 s
later
xxxxxxxxxxxxx=Program version no.
32
*** FS-Controller Download ***
From
ver xxxxxxxxxxxxx
To(New) ver xxxxxxxxxxxxx
Erase
completed.
Writing...
xx%
Push Reset switch
S1 until the menu
shown below appears
on the Control Unit.
Lock icon
(brown)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs-2575Fs-5075

Table of Contents