How To Install Optional Equipment - Furuno FS-1575 Installation Manual

1.6

How to Install Optional Equipment

1.6.1 Preamp Unit FAX-5
The preamp unit can be mounted two ways: screwed on to a mast or fixed to a mast, using stain-
less steel hose clamps (optional supply). The mast should not be longer than 1.5 m (5 feet) to pre-
vent undue flexing in heavy winds.
For detailed installation procedure, see the outline drawing for the preamp unit.
1.6.2 Printer PP-510
Refer to the outline drawing at the end of this manual for mounting dimensions and recommended
maintenance space. Follow the compass safety distance shown in the Safety Instructions to pre-
vent interference to a magnetic compass. Connect the interconnection cable between the printer
and the Control Unit (or Printer Interface). For how to load paper and set ribbon cassette, refer to
the Operator's Manual of the printer.
Fix the printer to the mounting location with the two mounting fixtures provided.
Mounting Fixture (1)
1.6.3 Printer Interface IF-8500
Refer to the outline drawing at the end of this manual for mounting dimensions and recommended
maintenance space. Follow the compass safety distance shown in the Safety Instructions to pre-
vent interference to a magnetic compass. Fasten the Printer Interface with self-tapping screws (lo-
cal supply) to desktop or bulkhead.
1.6.4 External Loudspeaker SEM-21Q
The external loudspeaker can be installed on a tabletop, the overhead or bulkhead. Follow the
compass safety distance shown in the Safety Instructions to prevent interference to a magnetic
compass. See the outline drawing at the back of this manual for mounting dimensions and recom-
mended maintenance space. Select a location that is within 2.8 m of the Control Unit because that
is the length of the connection cable. Fasten the loudspeaker to the mounting location with the
self-tapping screws (supplied).
1. HOW TO INSTALL THE SYSTEM
Mounting Fixture (2)
8