Pre-Installation Considerations - Maytag STACKED WASHER- DRYER Installation Instructions Manual

2a-O EdwardsStreet.SE
Cleveland, T ennessee 3 731 i
Tei:423-4723352,
Fax:_.23-478-6710
PREINSTALLATION CONSIDERATIONS
Location: The stacked washer/dryer is approved for zero clearance installation on the sides
and the back (depending on venting used). The location selected must take into consideration
the dimensions of the unit and convenience for customer use and access in case service should
be needed. The floor must be capable at supporting the weight of the unit (approximately
340 pounds) plus water (approximately 130 pounds) and be stable enough to prevent exces-
sive vibration in spin cycles. A floor which is adequate for the standard washer is sufficient
for the stacked washer/dryer.
The following specifications and drawings show dimensions and locations of fill valve, ter-
minal block (electric dryer) gas inlet (gas dryer) and drain outlet.
STACKED WASHER AND DRYER
Basic Dimensions 27 1/2" W x 27 1/2" D x 73" H (min). See drawings for complete
dimensions. Uncrated Weight: Approximately 340 pounds.
KEY FACTS - WASHER
Capacity: Standard (16 gallons)
Water Usage: (full cycle) - 36 (30 Imp.) gal: 136 liters - large
30 (25 Imp.) gal: 114 liters - medium
24 (20 Imp.) gal." 91 liters - small
Motor: 1/2 H.E rated; 115 volt; 60 Hz; reversible; thermoprotected against overload;
automatic reset. Model LDE7804 available in 220-240 volt; to Hz.
Power: O. 1 - O.17 kwh depending on cycle.
Hose Lengths: Inlet 5 feet (1.52 m); drain 4 feet (I.22 m).
Installation Requirements: Hot and cold water connections with water pressure within 30-
120 p.s.i. (2.11-8.44 kg/cm) range; 120F to 140F hot water; a drain; a 120 volt, 60Hz
electrical outlet properly grounded and protected by a 15 amp fuse.
Uncrated Weight: Approximately 340 pounds.
_"_ MA'_r._.C
.ldm|rai _1 "_w'i" J E N N -,,_II=I _MilcJi¢ C ,"'le|