Additional Information - Maytag STACKED WASHER- DRYER Installation Instructions Manual

Caste_er Se,_,in_ a_jLA _
240 Edwards Street,SE
Cleveland, T ennessee 3731
Tel:423-472-3333
Fax:423-478-6710
If the unit is a microprocessor stacked washer/dryer, connect the washer power cord to the
120 volt AC outlet.
Slide washer back into position. A peg on the back right corner of the washer will locate in a
socket on the right leg of the dryer stand.
Adjust the washer front legs down against the floor to raise the washer front slightly. The
washer should be level side to side and just barely higher in the front than in the back (bubble
just touching in the level). Lock leveling leg in position using leg lock nuts.
Remove all instruction packages from washer tub and dryer drum before using units.
Remove tub block ring from washer tub opening.
ADDITIONAL INFORMATION
ODD CYCLE OPERATION
This Maytag stacked washer/dryer is manufactured for operation on 60 Hz approved electri-
cal service. It is not designed for use on 50 Hz AC electrical service and conversion of the
product from 60 to 50 cycle operation is not recommended. For additional information on 50
cycle products, write, MAYTAG INTERNATIONAL, 8700 Bryn Mawr Ave. Chicago, IL
60631. Or call 312-714-0100 (FAX 312-714-8180).
LUBRICATION
No routine lubrication is required to maintain the stacked washer/dryer. In the event some-
thing does need attention, contact an authorized Maytag dealer or servicer.
MA_I'AG Aamira| 7] _ JENN-A_I::I _lla_l_:: C_ef