Maytag STACKED WASHER- DRYER Installation Instructions Manual page 23

Cu_0mer Sa_'ica _t[A]Ip]_
240EdwardsStreet,SE
C!eveiand, Tennessee 37311
Te_: 4 23-472-3333
Fax: 4 23-478-6710
If not previously done, remove shipping pads from washer top.
Move the washer into position in front of the dryer and stand. Use caution to avoid floor
damage because of the minimum height of the rear legs.
Tip forward enough for glides to clear the legs of the stand, and guide the glides into the slots
on the top of the stand legs.
Lower Washer Glide
Bar Down into slot.
Slide Washer Back
onto Stand
/
Before sliding washer back into position, connect fill hoses.
Be sure the gooseneck is fully inserted into the drain standpipe to prevent any chance of the
hose coming out of the standpipe from the force of the water being discharged.
Connect the-two control cables, one from the dryer and one from the washer, as shown.
[]
MA_r, XG Admiral 7l :Ua_JENN-,X_R "_laqic C.._et