Percent Command Set; Remote Access Commands - US Robotics COURIER User Manual

-
-
-
-
-
-
&Yn
COURIER HIGH SPEED MODEMS
&X2 Modem's Receiver clock is the source; valid only in V.32
bis mode or for 2400/1200-bps connections in HST mode.
Break handling. Destructive Breaks clear the buffer; expedited
Breaks are sent immediately to the remote system. Under data
compression, destructive Breaks cause both modems to reset
their compression tables.
& YO Destructive, don't send Break.
&Yl Destructive, expedited (Default).
&Y2 Nondestructive, expedited.
&Y3 Nondestructive, unexpedited; modem sends Break in
sequence with data received from DTE.
&Zn=s Write the following Dial string (s) to NVRAM at position n
(n
=
0-3).
&Zn? Display the phone number stored in NVRAM at position n
(n
=
0-3).
&ZC=s Write the following command string (s) to NVRAM.
&ZC? Display the stored command string.
PERCENT COMMAND SET
%Rn Rack Controller Unit (RCU) access. For use with USRobotics
Total Control Modem Management Systems.
%RO Normal operations, RCU access disabled (Default).
%R1 RCU access enabled.
% T Touch-Tone Recognition mode enabled.
Remote Access Commands
The following commands are valid only during remote access
sessions, which are described in Remote Access in Appendix E.
o/oBn Configure the Courier's serial port rate.
%BO 110 bps.
%Bl 300 bps.
%B2 600 bps.
continued
Command Summary C-11