US Robotics COURIER User Manual page 65

COURIER HIGH SPEED MODEMS
NOTE: Additional messages indicate an error-control connec-
tion and the modulation for a call. See Additional Result Code
Subsets (&An), earlier in this chapter.
Result Code
0/0K
1/CONNECT
2/RING
3/NO CARRIER
4/ERROR
5/CONNECT 1200
6/NO DIAL TONE
7 /BUSY
8/NOANSWER
10/CONNECT 2400
11/RINGING
12/VOICE
13/CONNECT 9600
Adaptive Dialing
Wait for Another
Dial Tone (W)
Wait for an
Answer(@)
Fast Dial
Meaning
Command has been executed
Connection with another modem; if set to XO, connection
may be between 300 and 16.8 bps; if Xl or higher,
connection is at 300 bps
Incoming ring detected
Carrier detect has failed or carrier has been dropped due to
disconnect
Command is invalid
Connection with another modem at 1200 bps
Dial tone not detected during the normal 2 seconds, set in
Register S6
Busy signal detect; modem hangs up
After waiting 5 seconds for an answer, modem hangs up;
returned instead of NO CARRIER when the @option is
used
Connection with another modem at 2400 bps
The modem has dialed; remote phone line is ringing
Voice answer at remote site; modem hangs up
Connection at reported rate. Same meaning for results of
4800 (18), 7200 (20), 12K (21), 14.4K (25) and 16.8K (43, HST
only).
The modem attempts to use Touch-Tone dialing and, if that
doesn't work, reverts to rotary dialing.
The modem continues dialing as soon as it detects
another dial tone. See the dial options in Chapter 6.
The modem continues dialing when it detects 5
seconds of silence on the line. See the dial options in
Chapter 6.
The modem dials immediately on dial-tone detect, instead
of waiting the normal 2 seconds set in Register S6.
Table 5-2. Result Code Definitions
5-8 Internal Controls
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-