US Robotics COURIER User Manual page 160

-
-
COURIER HIGH SPEED MODEMS
1. Make sure the Courier has been set for remote configuration,
as described earlier, and establish a connection. It does not
matter which modem originates the call.
2. After a connection has been established, send the following
3.
escape sequence.
Pause four seconds,
type four tildes: ----
and
pause another four seconds.
NOTE: You can change the escape sequence character with
Register S42. The pause duration (guard time) can be
modified with Register S43. (These values are set at the
Courier modem.)
When the Courier begins its login sequence, the caller will
see the following display (or a similar display) on his
screen.
USRobotics Courier 16800 HST Dual Standard Remote
Serial Number OOOOOOA000000001
4 . At this point, if password security is active, the caller is
prompted for the password.
Password (Ctrl-C to cancel)? .....
As described earlier in Password Security, entering the pass-
word assigned with %PO allows viewing privileges only.
Entering the password assigned with %Pl allows viewing
and configuration privileges. Note that there is a 3-minute
time limit for entering the password.
When a password is accepted, the Courier indicates that it
has entered Remote Access mode and the remote prompt
appears on the caller's screen.
Access Granted
Remote->
As mentioned earlier, if the number of unsuccessful login
attempts exceeds the set limit, the modem returns online and
refuses any further login attempts during the remainder of
that connection.
Fax and Other Operations E-9