Table of Contents
Advertisement
<-Exit
Click on this option to return to the Output submenu
<-Exit
Click on this option to return to the Input/Output menu.
AM Options (AM Style Only)
<-Exit
Click on this option to return to the Output submenu.
Polarity Controls
These controls adjust the polarity for each of the 2 analog outputs separately. The "A" output
refers to the Left channel output and the "B" output refers to the Right channel output. These are
handy to use instead of swapping pins 2 & 3 on XLR connectors or if the wiring is inaccessible.
There are two available settings for each polarity control: "Normal" and "Invert"
[ANA A Pol] (Analog Output Polarity for the Left Channel)
[ANA B Pol] (Analog Output Polarity for the Right Channel)
[AES A Pol] (AES/EBU Digital Output Polarity for the Left Channel)
[AES B Pol] (AES/EBU Digital Output Polarity for the Right Channel)
[LW A Pol] (Livewire Output Polarity for the Left Channel)
[LW B Pol] (Livewire Output Polarity for the Right Channel)
[Asym Mod] (Assymetrical Modulation)
Asymmetrical positive modulation is possible by adjusting the Asym Mod parameter to
some value other than 100%. This will increase the modulation on positive peaks only.
The range of adjustment allows asymmetry up to 150% of the negative modulation value.
NOTE: Be sure the output polarity is set / wired properly for your transmitter. If it is
wrong, this control can increase negative peaks instead!
[LPF Freq] (Low-Pass Filter Frequency)
This control adjusts the cutoff frequency of the Omnia's post clipper NRSC-compatible
low pass filter.
Cutoff frequency settings of 4.5, 5, 5.5, 6, 7, 8 and 10 kHz are available.
74
Advertisement
Table of Contents
